Soundguard
should remain stacked on its edge with
appropriate edge and corner protection
removed only at the point of installation.
Soundguard should not be stacked in wet
conditions or in direct sunlight prior
to installation.
Glazing
All glazing
must be carried out in accordance with
our installation provisions. Typical weight:
2.56kg/m2/mm thickness
• Thickness range from 7.0mm
• Minimum size: 100mm x 100mm (on
all types)
• Maximum size: Please call for
details
• Manufacturing tolerance: +/- 3mm
In accordance
with BS EN 952 and GGF standard for the
Quality of Thermally Toughened Glass for
Building
Safety
Requirements
Soundguard
is a structural safety product and is
not designed to withstand pedestrian traffic
defined in BS6399. Soundguard products
should only be installed using approved
compatible glazing materials (please refer
to Glazeguard Ltd for further information).
Where edges are likely to be exposed to
moisture then we strongly suggest that
a form of edge protection is applied.
Mechanical and structural calculations
are available at a cost to be agreed.
Soundguard should not be installed in
applications where sustained temperatures
exceeding 60°c will be experienced.
General
notes:
Bubbles
During
the laminating process it is possible
that small air bubbles may be entrapped;
these may naturally disperse during the
curing process. Any latent defects may
be treated and will not adversely affect
the performance of Soundguard products.
Bubbles under 3mm in diameter and not
visible from 3 metres away in normal daylight
will be deemed acceptable.
Specifiers
An edge
tape may be evident unless otherwise specified.
Completion of mechanical and thermal safety
checks for any application remains the
responsibility of the person(s) placing
the order.
